CAUTION: Most electric dryers use 220 volts to power the heating element. Always disconnect the dryer power cord from the wall receptacle before doing any tests or repair work.
Here are some tips.
Check the fuses
If you have an electric dryer, the first thing to check are the fuses or breakers in your homes fuse box. If this fuse is blown, it is possible for your dryer to spin but not produce heat. If you’ve checked the fuses and they are not blown, the next possible cause is the heating element Dryer Repair Los Angeles.
Check the heating element
To check the heating element, move the back panel of the dryer. You’ll need a volt/ohmmeter to check the element terminal. Locate the element and set the volt/ohmmeter on the RX-1 scale. Remove one lead from the element and then place one probe of the volt/ohmmeter on the terminal of the element. Place the other probe of the volt/ohmmeter on the remaining terminal of the element. Look for a continuity reading of the volt/ohmmeter of approximately 2-5 ohms. If there is no continuity reading, the heating element is defective and should be replaced.
LINT- Your dryer’s greatest enemy
To extend the life of your dryer, clean the lint filter every time you use the dryer. Even if the lint filter is cleaned after every load, lint will still accumulate around the dryer’s moving parts, the exhaust duct and vent.
Each year inspect the vent pipe and vent cover operation. Disconnect the exhaust duct and remove lint from the internal exhaust pipe, the duct and the vent. Make sure the duct has no kinks, where lint and moisture can build-up.
Turn off the power, remove the front and rear panels and vacuum out the lint from around the motor and idler.Poor air flow uses more energy and can cause lint build-up in the internal ducting, leading to a fire hazard.